Page History

When you are working with ANPR list, you can configure the macros to trigger on the following events:

• if the target  number shows up in the selected ANPR list;
• if the target  number does not show up in the selected ANPR list;
• recognition of a specific number from the selected ANPR list;
• if the target  number does not show up in all available ANPR lists;
• recognition of any number from any ANPR list.

Target number shows up in the selected ANPR list

In this case, configure the macro as follows:

1. Go to the Start conditions in the License plate recognition list and select the required ANPR list (1).
2. Leave the field 2 empty.
3. The status of the Presence toggle (3).

The target  number does not show up in the selected ANPR list

In this case, configure the macro as follows:

1. Go to the Start conditions in the License plate recognition list and select the required ANPR list (1).
2. Leave the field 2 empty.
3. The status of the Absence toggle (3).

Recognition of a specific number from the selected ANPR list

In this case, configure the macro as follows:

1. Go to the Start conditions in the License plate recognition list and select the required ANPR list (1).

To set an automatic response to an FR event, do as follows:

1. Create a macro (see Create Macros).
2. As a starting condition, select the License plate recognition event and the desired list (1, see Configuring filters for event-driven macros).
   Image Removed
3. By default, the macro is triggered by recognition of any number from the list. If required, you can specify a particular number whose recognition will trigger the macro (2)

   Select a specific number plate in field 2

   .
   

   Info
   title Note
   To select another number, clear the 2 field and re-open the list.

4. Program an action or a sequence of actions to be performed in response to an identification of a recognized LP against the designated list (see Settings specific to actions).

5. 
   

6. The status of the Presence toggle (3).

The target  number does not show up in all available ANPR lists

In this case, configure the macro as follows:

1. Go to the Start conditions field in the License plate recognition list and select  Not listed (1).
2. Leave the field 2 empty.
3. The status of the Presence toggle (3).

Recognition of any number from any ANPR list

In this case, configure the macro as follows:

1. Go to the Start conditions field in the License plate recognition list and select  Not listed (1).
2. Leave the field 2 empty.
3. The status of the Absence toggle (3).If the response involves initiating an alarm, you can configure the Dialog Board to filter Alarm Initiated by Macro Command events (see Configure the Dialog Board).
   Image Removed