Page History

The number of PTZ devices connected to the Server is specified in the license key bundled with INTELLECT Axxon PSIM™ distribution kit.  

Every PTZ device has the corresponding PTZ device systemobject in INTELLECT Axxon PSIM™. The PTZ device object is a child object to the Telemetry Controller object.

...

1. Go to the Hardware tab in the setting panel of INTELLECT Axxon PSIM™ (1).

2. Create a PTZ device object under the Telemetry controller object or select the relevant object in the object tree in the Hardware tab of the System settings dialog box (2).

   Image RemovedImage Added

3. Specify the ID, the name of the PTZ device object and select the Telemetry controller object to which the PTZ device is connected (3).

4. Select the ID of the camera equipped with a PTZ device (4).

5. Select the name of the camera equipped with a PTZ device (5).

   Info
   title Note
   Specify either the video camera ID or its name.

   
   

6. In the Presets table set checkboxes checked next to the names of presets that are to be displayed on Telemetry control panel (see Telemetry control panel configuration section). Change the preset's name if necessary (6).

   Info
   title Note
   In order to select all presets or cancel this operation, use the Select/Deselect checkbox (7). The maximum number depends on the device, see Appendix 6. Maximum number of presets for IP devices.

   
   

7. Set minimal and maximal speed of optical zoom in standard units for PTZ device in the Zooming group (8).

8. Set minimal and maximal rotation speed in standard units for PTZ device while mouse control from the Monitor in the Mouse group (9).

9. Set minimal and maximal rotation speed while joystick control in the Joystick group (10)

10. Set minimal and maximal rotation speed of PTZ device in direction of mouse click (Point&Click) in standard units for PTZ device in the Point&Click group (11).

11. Specify the MAC address of the PTZ device in the Device address field. The PTZ MAC address corresponds to the address set on the PTZ device with the help of jumpers or configured while programming the PTZ device in the the bundled software (12).

12. If the continuous PTZ mode (Continuous Mode) is to be disabled, set the Force disabling continuous PTZ mode checkbox checked (13).

    Info
    title Note.
    If the checkbox is set unchecked, then the continuous PTZ mode is automatically enabled for the PTZ devices that support it.

    
    

13. To save the changes click the Apply button (14).