Page History

Interaction with Manitou software means sending messages on the event from Intellectto the Server with installed Manitou software. Messages contain info on the events and alarm video can be attached to such message.

...

1. Go to the settings panel of Manitou object.
   
2. In the IP field specify the IP address of the Server where Manitou software is started and to which the connection is to be performed (1).
3. In the Port field specify the port number to connect to the Server with Manitou software (2).

4. In the Avi duration (sec.) field specify the period of delay after the event happens and before sending the message with attached video (3).

   Info
   title Note
   For correct video export, in the Tweaki.exe utility set maximum frames in one video file so the video fragment duration is shorter than the delay (for instance, 100). Otherwise it may happen that recording of the required fragment of video archive has not stopped yet when sending the message. See The Settings panel of the Video subsystem section (the Frame count parameter).

   
   

5. In the objtype dropdown drop-down list select the type of object by the event from which the message is to be sent to Manitou software (4).

   Note
   title Attention!
   If you don’t select any object, messages about all objects of the system will be sent to Manitou software. This can significantly increase the system load, as a large number of video fragments will be generated.

   
   

6. In the objid dropdown drop-down list select the ID of object of the selected type (5).
7. Left-click in the objname field (6). It is automatically filled with the name of corresponding object.
8. In the event dropdown drop-down list select the event from the object of the selected type – when this event happens the message is sent to Manitou software (7). If the event is not selected, then messages will be sent at any event from the selected object.
9. In the cam_name dropdown drop-down list select the Camera object the video fragment from which is to be attached to the message (8).

10. Repeat steps 5-9 for all required objects and events.

    Info
    title Note
    Press the down arrow on the keyboard to add a line to the table.

    
    

11. Click the Apply button (9).

...