Versions Compared

Old Version 3

changes.mady.by.user Evgeniya Kononova

Saved on

compared with

New Version 4

changes.mady.by.user Gleb Matskevich

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

All basic detection tools have a number of common settings.

  1. If a camera supports multistreamingmulti-streaming, select the stream for which detection is needed (1). Selecting a low-quality video stream allows reducing the load on the Server.

  2. The default setting for all detection tools is Decode only key frames (2). In this case, the only key frames are processed every 500 milliseconds or less often. To disable Decode decoded. To disable the decoding of key frames, select No in the appropriate fieldcorresponding field.

    This setting applies to all codecs. If a codec has keyframes and p-frames, the keyframe is decoded no more often than every 500 miliseconds. For the MJPEG codec, each frame is considered to be I frame.
    Note
    titleImportant
    Attention!

    This feature reduces the Server load but, as can be expected, negatively impacts the quality of detection.

    This setting should be activated on "blind" Servers (Servers that do not display video) on which it is necessary to perform detection.

    For the MJPEG codec, each frame is considered a key frame.


  3. Select a processing resource for decoding video streams (3). When you select a GPU, a stand-alone graphics card takes priority (when decoding with NVidia NVIDIA NVDEC chips). If there's no appropriate GPU, the decoding will use the Intel Quick Sync Video technology. Otherwise, CPU resources will be used for decoding.

  4. Event duration to trigger detection (sec.) is the maximum time for detection of the event duration after which the detection tool will trigger (4). But, the detection tool can trigger even earlier if the algorithm undoubtedly determines the noise. If the bad image is not detected within the specified time, change the sensitivity settings the detection tool does not trigger after the event duration time expires, it means that the corresponding image defect was not detected with the specified detector sensitivity (6).
  5. Set the frame rate value for each detection tool to process (5). This value should be in the range [0.016, 100]. 
  6. Sensitivity of detection tool operation in standard units from 0 to 100 100 (6).

To save settings, click the Apply button.