Versions Compared

Old Version 3

changes.mady.by.user Evgeniya Kononova

Saved on

compared with

New Version 4

changes.mady.by.user Alena Kniazeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

To configure the filtering of the vehicle plates, proceed as followsdo the following:

  1. Go to the LPR channel object settings panel, corresponding to the activated module (see Activating the software module used for identifying the plates section).
    Image Added
  2. Go Switch to the the Saving settings tab (1).Image Removed
  3. In the Min. number of characters in LP field indicate (2), specify the minimum number of characters in the recognized number (2).
  4. In the Min. recognition quality, % field indicate (3), specify the minimum recognition quality in percent (3).
  5. In the Min. time of LP repetition, s field (4), specify the minimum time in seconds of number repetition on in the video (4)in the range 0-3600.  
  6. Click the Apply button (5) to save the settings (5).

Setting up the filtering of the recognized LP numbers is completed.