Versions Compared

Old Version 2

changes.mady.by.user Darya Andryieuskaya

Saved on

compared with

New Version 3

changes.mady.by.user Alena Kniazeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Browsing across a selected recording segment uses You can navigate through the selected fragment of the record using playback controls.

The button starts playing back the selected recording segment, the  button stops playback.

When the  button button is left-clicked, the fast-forward playback is performed, when right-clicked – —rewind playback.

Only the current selected recording of the archive is played back when the  button is short-clicked. Hold the  button to start playing pack the next recording after the end of playing back the previous one.

Info
titleNote

It is possible to You can change the way playback is controlled so that by short left-click the recordings are played back continuously, and only one selected recording is played back back by long click. For this, use the LButtonClickContinuousPlayEnable registry key can be used (see Registry keys reference guide).

The and  buttons increase or decrease the frame rate or slide show rate in the pause mode.

SpeedDuring fast and slow playback, speed-up or speed-down level is displaying displayed in the place of the  button while fast or slow motion. The button, while the functionality of the button remains the same. The maximum possible speed-up is 998 times, the maximum possible speed-down is 8 times.

Note
titleAttention!

If recordings from the Edge storage are used for playback, the maximum possible level of speed-up and speed-down depends on the limitations of a camera (see functional characteristics of an IP camera in the control panel of its Web interface). 

When there is fast and slow playback of video from the archive, the recorded sound of the archive recording is not played back.

Info
titleNote

When there is you fast playback of the archive in H264 H.264 and MPEG4 format, starting at x12 speed only the key frames are played back:

  • starting from 8x speedup when playing back backward regardless of the number of cameras selected for playback;
  • starting from 4x speedup when playing back forward
and at x8 speed when playing back backward, only the key frames are played back
  • if several cameras are selected;
  • starting from x12 speedup when playing back forward if one camera is selected. This setting is specified in the MonitorForwardSkipSpeed registry key (see Registry keys reference guide).

When hovering the mouse cursor over the playback control panel, the playback speed can be controlled using the mouse wheel. The playback speed changes smoothly as follows:

...

To shift to the pause mode, press click the  button button, to restore playback – press the —click the button.