Page History

x32: (x32-ATM Event Capture)

x64: (x64-ATM Event Capture)

JrnTOut

>0

10

от from 9.0

Timeout in seconds for waiting for the information about the card insertion to appear in the ATM log after the actual card insertion.

For m_JrnMode=2 mode only (MAK3 TUSSON)

x32: (x32-ATM Event Capture)

x64: (x64-ATM Event Capture)

Specifies the options for masking the card number. By default, the first 6 and last 4 characters of the card number are not masked.

0 – if no mask to be applied to the card number.

1-6 – number of digits in the beginning of the card number which are not masked.

x32: (x32-ATM Event Capture)

x64: (x64-ATM Event Capture)

Defines the mode of operating the journal.

0 – card number is read from the card reader

1 – card number is read from the ATM journal through the Protopas software (Wincor)

2 – card number is read from the ATM journal through the MAK3 (TUSSON) software

3 – card number is read from the ATM journal through the TellMe (SCS) software

4 – card number is read from the ATM journal through the APTRA Advance NDC (NCR) software

x32: (x32-ATM Event Capture)

x64: (x64-ATM Event Capture)

Specifies the path to the ATM journal.

If JrnMode = 1, then JrnPath = C:\JOURNAL\

If JrnMode = 2, then JrnPath = C:\scs\atm_h\PRJ\

If JrnMode = 3, then JrnPath = C:\scs\atm_h\PRJ\

If JrnMode = 4, then JrnPath = C:\program files\ncr aptra\advance ndc\data\

x32: (x32-ATM Event Capture)

x64: (x64-ATM Event Capture)

Specifies the substring for searching the card number.

If JrnMode = 1, then JrnTrack2Substring = (TRACK 2 DATA)

If JrnMode = 2, then JrnTrack2Substring = @++

If JrnMode = 3, then JrnTrack2Substring = CARD

If JrnMode = 4, then JrnTrack2Substring = CARD

x32: (x32-ATM Event Capture)

x64: (x64-ATM Event Capture)

Enables logging the ATM Event Capture utility operation

0 - event log is disabled

1 - event log is enabled. After you quit and start ATM Event Capture utility again, the EventATM.log file appears in the installation folder.