Versions Compared

Old Version 1

changes.mady.by.user Alena Kniazeva

Saved on

compared with

New Version 2

changes.mady.by.user Alena Kniazeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. From the Additional hardware drop-down list (1), select the type of hardware connected to the BioSmart 4 controller:
    1. No—additional hardware isn’t connected.
    2. BioSmart RCU—the BioSmart relay control unit (RCU) is connected to the controller.
    3. CK-24—key dispenser is connected to the controller.
    4. Kronwerk—controller works in the integration mode with the Kronwerk ACS under the Kronwerk software control.
    5. BioSmart BOX—the BioSmart BOX cell monitoring hardware is connected to the controller.
    6. Perco—controller works in the integration mode with the Perco ACS under the Perco software control.
  2. From the Wiegand Out drop-down list (2), select the protocol type of the Wiegand output interface of the BioSmart 4 controller:
    1. Not used—the Wiegand output interface of the BioSmart 4 controller isn’t used.
    2. Wiegand-26 (W/P)—hardware that uses the Wiegand 26 protocol with parity check bits is connected to the Wiegand output of the BioSmart 4 controller.
    3. Wiegand-32—hardware that uses the Wiegand 32 protocol is connected to the Wiegand output of the BioSmart 4 controller.
  3. From the Wiegand In drop-down list (3), select the protocol type of the Wiegand input interface of the BioSmart 4 controller:
    1. Not used—the Wiegand input interface of the BioSmart 4 controller isn’t used.
    2. Wiegand-26—reader that uses the Wiegand 26 protocol is connected to the Wiegand input of the BioSmart 4 controller.
    3. Wiegand-26 (W/P)—reader that uses the Wiegand 26 protocol with parity check bits is connected to the Wiegand input of the BioSmart 4 controller.
    4. Wiegand-32—reader that uses the Wiegand 32 protocol is connected to the Wiegand input of the BioSmart 4 controller.
  4. If you want to enable the bypass mode, select the On value from the Bypass mode drop-down list (4). In this case, the map access card not registered in the ACFA PSIM database will be available for transmission to the external ACS controller via the Wiegand output of the Biosmart 4 controller. The default value is Off.

...