Page History

Zone groups allow you to combine zones (AIO and/or AIM inputs and/or status , service inputs), mask and unmask the entire group.

Zone group configuration is performed on the settings panel of the Apollo Zone group object settings panel. The object is created under on the basis of the Apollo AAN object on the Hardware tab of the System Settingssettings dialog boxwindow.

Image ModifiedZone

group configuration is performed as followsTo configure the zone group, do the following:

1. Go to the settings panel of the Apollo Zone group object settings panel.Image Removed
2. From Select zone group ID in the controller from the Number drop-down list (1), select number of the zone group in the controller .
3. From the Initial masking level drop-down list (2), select the initial masking level. If the masking level is not zero, then the group is considered to be masked, if zero – zero—the group is unmasked.
4. From the Maximum masking level drop-down list (3), select the maximum masking level.
5. Set checkboxes next to the objects to that must be included in the group (4).
6. Click the Apply button.
7. To save the changes to the controller, write configuration to hardware.
   

...