Versions Compared

Old Version 8

changes.mady.by.user Evgeniya Kononova

Saved on

compared with

New Version Current

changes.mady.by.user Alena Kniazeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

To configure speed estimation by video, do the following:

  1. Go to the  settings panel of the LPR channel object settings panel, corresponding to the activated module module (see Activating the software module used for identifying the plates).
  2. Go to the Speed camera settings tab (1).
  3. Set the Get speed from video checkbox (2). As a result, settings for speed estimation become available.
  4. Click the Configuration button (3). The Get speed from video dialog box openswill open.
    1. Click the  button.
    2. Add a line segment of a known length in centimeters to the video image (1).
    3. Click the OK button (2) to save changes and .
      The       Get speed from video dialog box will close, and you will return to the control settings panel of the LPR channelchannel object.
  5. In the the Distance field (4), enter in centimeters the length of the previously specified line segment in centimeters (4)specified in the Get speed from video dialog box.
  6. Enter permitted vehicle speed in the the Permitted speed...km/h field (5).
  7. Enter maximum vehicle speed in the the Alarm on speed limit...km/h field field (6). If this speed is is exceeded, an alarm event is generated (6).
  8. Click the the Apply button (7).

Configuring speed estimation by video is completed.