Versions Compared

Old Version 1

changes.mady.by.user Alina Luchkina

Saved on

compared with

New Version 2

changes.mady.by.user Alena Kniazeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

To configure the Hands up detection, do the following:

  1. Create Pose Detection (see Configuring Pose Detection).
  2. Below the Pose Detection, click Create… → Hands up detection.

By default, the The Hands up detection tool triggers if there is a person with one or both hands raised is detected in a specified area.

If necessary, you can change the detection tool parameters. The list of parameters is given in the table:

ParameterValueDescription
Other
EnableYes

To configure the Hands up detection tool, do the following:

...

The detection tool is enabled by default. To disable the detection tool, select the No value
No
Name Hands up detectionEnter the detection tool name or leave the default name
TypeHands up detectionName of the detection tool type (non-editable field)
Basic settings
ModeBoth handsSelect this value if you want the detection tool to trigger only when a

...

person has both hands raised

...

One hand

...

Select this value if you want the detection tool to trigger only when a person has either left or right hand raised
Only leftSelect this value if you want the detection tool to trigger only when a person has one selected hand raised
Only right
Left handSelect this value if you want the detection tool to trigger only when a selected hand is raised
Right hand
Number of measurements in a row to trigger detection2

Specify the minimum number of frames with a person with a hand/hands raised for the detection tool to trigger. The value must

...

be in the range [1

...

, 20].
The recommended (default) value is 2.
Increasing the value can help eliminate false alarms, but increases the risk of skips. 
Decreasing the value can help reduce skips, but increases the probability of false alarms

Info
titleNote
  • The Hands up detection
tool
  • works in
the
  • the areas for detection and skip areas specified in the Pose
detection tools (see Setting up common parameters for Pose detection tools).
  • Detection (see Configuring Pose Detection).
  • For convenience of configuration, you can "freeze" the frame. Click the Image Added button. To cancel the action, click this button again.
  • The area for detection is displayed by default. To hide it, click the Image Added button. To cancel the action, click this button again.

To save the parameters of the detection tool, click the Apply Image Added button. To cancel the changes, click the Cancel Image Added buttonConfiguring the Hands up detection tool is complete.