Versions Compared

Old Version 5

changes.mady.by.user Evgeniya Kononova

Saved on

compared with

New Version 6

changes.mady.by.user Alena Kniazeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section


Column
width50%


Panel
borderColor#CCCCCC
bgColor#FFFFFF
titleBGColor#F0F0F0
borderStylesolid
titleOn the page:
Table of Contents



Column


Tip

XML-file parameters reference guide


Note
titleAttention!

The You must configure the Face recognition report and Report by employee passes with photo configuration must be performed on the computer where it is planned to on which you will work with these reports.

After making any changes in the Web.config file, it is necessary to restart the you must restart Cassini Service utility..

Activating the Face recognition report and Report by employee passes with photo

For the the Face recognition report and Report by employee passes with photo to work, it is necessary to you must specify the address of the server where the on which Axxon PSIM software package is locatedinstalled. To do this:

  1. Go to the <<Axxon PSIM installation directory>\Modules\Wt2.
  2. Open the Web.config file for editing.
  3. For the ReportSystemHost key, set specify the IP address of the server on which Axxon PSIM is located. If you are working with the reports on the same computer where on which Axxon PSIM is installed, set specify localhost.
  4. Save the changes in the Web.config file.

The Face recognition report and Report by employee passes with photo are activated.

Changing the number of faces in one file of the Face recognition report

When you save the Face recognition report, it is split into files of 1000 faces each, by default. To change the number of faces in the files of the report when saving:

  1. Go to <Axxon PSIM installation directory>\Modules\Wt2.
  2. Open the Web.config file for editing.
  3. For the FaceRecognizedMaxRows key, specify the number of faces in each file of the report when saving the results. The default value is 1000.
    Image Added
  4. Save the changes in the Web.config file.

The number of faces in each file of the Face recognition report is changed.