Page History

This command starts the replication process.To  To configure the command, perform do the following:

1. Configure on-demand replication (see Configuring data replication) if replication is performed from the archive (see Configuring data replication). To replicate from the on-board storage (SD card or other storage embedded in the video camera)embedded storage of a camera, enable the corresponding object (The Embedded storage object).

2. Select a video camera or a group of cameras to replicate (1). An implicit selection of a video camera is also allowed − —Camera that initiated command execution (see Configuring start conditions for event-driven macros).
   

   Note
   title Attention!
   If the start of the macro was triggered by the activation of an event from an input or output (see Configuring start conditions for event-driven macros) that is not connected to any camera, you need to select a specific camera here. If you select a group of cameras or a camera that triggered initiated the command, the action will not doesn't start.

3. Select an archive file to which video recordings videos will be replicated (2).

4. Select the replication period (3).

   Option	Description
   Whole period	All missing video recordings videos made prior to the command start time will be are copied.
   Offline periods	The system copies footage videos recorded to embedded storage (camera's SD card) during offline periods (between consecutive Signal lost and Signal restored events). If no Offset parameter (see paragraph step 5) is specified, the replication covers offline footage recorded during all corresponding intervals over the last 24 hours.
   Time schedule	Select a time schedule (see Creating schedules).All recordings  All videos made according to the time schedule settings for the last24hours prior to the command start time will be are copied.
   During:	Set the replication duration in HH:MM:SS. Video recordings Videos from the period [start action, start action + duration] will be are copied. An additional Offset parameter can be specified as needed (see step 5).
   Finish after	Select one or more end events. All video recordings videos between the start point (when the action starts) and the end point (when the event is received) will be are copied.Important  Attention! Replication will not start until the end event is received.

5. Specify Offset (4), if you specified the During parameter During: for replication in previous step. Video recordings Videos from the period [start action − offset, start action + duration − offset] will be are copied.

To run replication on schedule (corresponding to Time schedule 1), configure the macro as follows:

...