Page History

It is possible to open the You can open a layout with the specified camera.

...

1. Searches for the layouts available to the current user that contain the selected camera.
2. Selects the layout with the minimum number of cells to display the selected camera.
3. If the required layout does not exist, creates a new layout with the selected camera.
4. Switches to the selected layout, or the created layout.
5. Performs the specified action.

...

1. Configure the conditions to start a macro (see Configuring filters for event-driven macrosstart conditions).

2. Select the camera to be displayed (1) or Camera that initiated command execution (see Configuring start conditions). You can select a group of cameras for the Switch to archive mode (see step 2).
   

   Note
   title Attention!
   If the macro was triggered by a sensor or a relay (see an event from an input or output (see Configuring start conditions) that are is not associated with the camera, the action will not be triggereddoesn't start.

   

3. Select the display mode (2).

   Display mode	Description
   Select camera	The camera is highlighted on the layout
   Zoom in camera	The camera is highlighted on the layout, the viewing tile Surveillance window takes up 98% of the screen
   Zoom in and show map	The camera is highlighted on the layout, the viewing tile Surveillance window takes up 50% of the screen, the . The map under with the tile shows the selected camera is displayed
   Switch to immersion mode	Immersive mode is on, the viewing tile the Surveillance window takes up 50% of the screen
   Switch to archive mode	The camera is highlighted on the layout and it is in archive the Archive mode. If a group of cameras is specified, then a layout is created with all the cameras in archive the Archive mode
   Mark camera	The camera is added and highlighted on the Marked cameras layout (see Creating special layouts)
   Unmark camera	The camera is deleted from the Marked cameras layout (see Creating special layouts)

4. Specify the number of the monitor on which the selected camera should must be displayed (3).

5. Select the user roles, for which this macro will be is available (4).

The configuration of the View camera macro is complete.