Page History

...

To configure this action, do as followsthe following:

1. Configure the conditions to start a macro (see Configuring filters for event-driven macrosstart conditions).

2. Select a video camera or a group of cameras on which you want to stop an alarm (1). You can also implicitly select a camera—Camera that initiated command execution. 
   

   Note
   title Attention!
   If the start of the macro was is triggered by the activation of an event from an input or output (see see Configuring start conditions) that is not connected to any camera, you need to select a specific camera here. If you select a group of cameras or a camera that triggered initiated the command, the action will not doesn't start.

3. Select the alarm status (2).