Page History

...

1. Configure the conditions to start a macro (see Configuring start conditions).

2. Select the camera to be displayed (1) or Camera that initiated command execution (see Configuring start conditions). You can select a group of cameras for the Switch to archive mode (see step 2).
   

   Note
   title Attention!
   If the a macro was triggered is started by an event from an input or output (see see Configuring start conditions) that is not associated with the camera, the action doesn't start.

   

3. Select the display mode (2).

   Display mode	Description
   Select camera	The camera is highlighted on the layout
   Zoom in camera	The camera is highlighted on the layout, the Surveillance window takes up 98% of the screen
   Zoom in and show map	The camera is highlighted on the layout, the Surveillance window takes up 50% of the screen. The map with the selected camera is displayed
   Switch to immersion mode	Immersive mode is on, the Surveillance window takes up 50% of the screen
   Switch to archive mode	The camera is highlighted on the layout and it is in the Archive mode. If a group of cameras is specified, then a layout is created with all the cameras in the Archive mode
   Mark camera	The camera is added and highlighted on the Marked cameras layout (see Creating special layouts)
   Unmark camera	The camera is deleted from the Marked cameras layout (see Creating special layouts)

4. Specify the number of the monitor on which the selected camera must be displayed (3).

5. Select the user roles, for which this macro is available (4).

...