Versions Compared

Old Version 2

changes.mady.by.user Alena Kniazeva

Saved on

compared with

New Version 3

changes.mady.by.user Alena Kniazeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. From the Relay drop-down list (5), select the type of relay that will trigger at access: Aboard relay, Relay #1 RCU, Relay #2RCU.

  2. In the Timer, ms field (6), enter the time in milliseconds of the active state of the relay after clicking the relay control button in milliseconds. The default value is is 3000.

  3. To enable the trigger mode, from the Trigger mode drop-down list (7), select the On value. In this case, the relay will change its state each time the access is successful. When the controller power is on after an emergency shutdown, the relay will return to the state it was in when the power was off. The default value is Off.

  4. If you select the Manual mode from the Locking mode drop-down list (8), the locking is enabled when the Open button is enabled. Locking is disabled on the Close command.

    By timer—locking is enabled when the Open button is enabled. Locking is disabled after the time specified in the Timer, ms field (see step 2 of configuring working with exit relay).
  5. Click the Apply  button to save the changes.