Page History

General information

This action enables or disables the selected camera, detector, detection tool or input. .

Configuring an action

To configure this action, do as followsthe following:

1. Go to the Programming tab.
2. In the Event rules or Cycle rules list, click Create... (see Configuring macros).
3. Select a start condition that triggers
Configure the conditions to start
4. a macro (
see Configuring filters for event-driven macros).

5. Select the required object (1).

   Image Removed
Select the required command (2)
6. see Configuring start conditions).
7. Click the Image Added button below start conditions.
8. From the drop-down list, select Enable or disable component.
9. In the Component parameter, select the required object.
   Image Added
10. In the Enable or disable parameter, select the required operation.
11. Click the Apply Image Added button.

Configuration of the Enable or disable a component action is complete.