Go to documentation repository
Page History
...
After you added a camera to the configuration via the IP Device Discovery Wizard (see Searching, adding, configuring, and removing IP devices), you can edit the camera's parameters. The camera parameters are grouped as follows.
...
- If you want to use camera settings without overwriting them with the default settings specified in Axxon One, select Yes in the Use device settings field. This parameter is a reverse parameter of the Send settings to device checkbox, that is, when you enable one option, the other is automatically disabled, and vice versa.
- If you want to interrupt video streaming from the camera to the server when the camera isn't used by the system, select Yes in the Break unused connections field.
The following conditions must be met for the video stream transmission to be interrupted:Note title Attention! When you enable the Break unused connections parameter, additional time is required for stream initialization (to create a connection, request a stream, and so on) to display, start recording, or process a stream with a detector.
- Video stream isn't currently displayed on either the client or Web-Client
- web client layout.
- Video stream is currently not being recorded into an
- isn't currently bound to any archive.
- Video stream is
- isn't currently not
- being processed by any detector.
Authentication parameters
...
| Info | ||
|---|---|---|
| ||
You cannot edit these parameters if you added the camera in the Keep current settings mode (that is, with the parameters that were set in the web interface, see Searching, adding, configuring, and removing IP devices). To be able to configure these parameters, you need to set the Send settings to device checkbox. Once you set a checkbox for a camera, the checkbox is also set on all its channels and child objects. |
...
Overview
Content Tools