Page History

...

1. Configure the Video surveillance monitor (see Configuring video display on Video Surveillance Monitor);
2. Enable the Debug mode in Axxon PSIM using the tweaki.exe utility (see TweakiThe tweaki.exe utility for advanced setup of the Axxon PSIM software system, The Settings settings panel of the Axxon PSIM Base system section).

As a result, the current frame rates of the digitized video signals are displayed directly in the Video surveillance monitor. To get information about the frame rate of the video signal from the selected camera, display the Surveillance window corresponding to the selected camera in the Video surveillance monitor and activate this window by clicking it with the left mouse button. A window with video signal information is displayed in the upper right corner:

...

1. Go to the Hardware tab in the System settings window (1).
2. In the objects tree on the Hardware tab, select the Video capture device object created before that corresponds to the configured ADC of the video capture card (2). The settings panel for the selected object is displayed in the right part of the Hardware tab.
   Image Modified
3. If it is necessary to increase the total frame rate up to the maximum allowed value, move the Rate slider to the max position (3).
4. If it is necessary to reduce the total frame rate to the minimum allowed value, move the Rate slider to the min position. The minimum total frame rate of video signals, digitized and processed by a selected ADC, is three times lower than the maximum allowed one.
5. If it is necessary to return the default decimation settings, move the Rate slider to the middle position. The default total frame rate is two times lower than the maximum allowed one.
6. Click the Apply button (4).
7. Close the System settings window and restart Axxon PSIM.

...