Page History

To configure the To configure a POS device, do as follows:the following:

1. Create the Event source object; the manufacturer is POSLegasy (see Event source object).

2. Select the Event source object in the hardware tree on the Hardware tab.

3. Select the POS device connection type

4. Select the Event source object.

Select a connection type of the POS device
5. (1).
   Image Modified
Specify
6. Set the
Server
7. POS device connection port (2).
8. To connect via the RS-232 interface, select
connection
9. the post speed and parity
check
10. control (3).
11. Select the type of
your
12. the used POS device (4).

13. Select Yes in the DOS to WIN Conversion field if the data from the POS device is DOS-encoded (5).

14. If the data is UTF-8 encoded from the POS device,

select

15. select Yes in the Initial UTF-8 Format field to enable the correct display of captions (6).

16. If
a
17. you use the Retalix POS-terminal
is used
18. ,
select 
19. select Yes in the corresponding field (7).

20. Set the maximum size of the UDP

datagrams

21. packages in bytes (8).

Oversized packets will be

22. The packages whose size is greater than the set one are ignored. 

23. Click the Apply button.

You have successfully connected your Connecting the POS device is complete.