Page History

...

The SL USBIO board is an interface device designed for integrating external sensors and actuators (relays) into video surveillance and fire alarm systems. The 4x4 and 16x8 boards are supported.

Key technical specifications:

...

1. Using automatic device search (see Searching, adding, configuring, and removing IP devices). Do the following:
   1. In the Axxon One client, go to the Devices tab → Add device.
   2. In the Add device section:
      1. Click the Search button. Axxon One performs the search, and all available devices, including SL USBIO boards, are displayed in the Devices found (n) list.
      2. Select the found SL USBIO board.
      3. Click the button. 

2. Manually. Do the following:

   1. Open the Windows Device Manager.

   2. Go to the USB Controllers tab.

   3. Find the Stream Labs USB-IO 16|8OWDint device. If it is not isn't listed, you must check the physical connection of the board to the computer (make sure that the board is inserted into the computer's motherboard and recognized by the system).

      Note
      title Attention!
      If the board isn't displayed in the device manager, you must install the driver manually. To do this, you must download the archive and select the folder with the x64 driver or the w2k folder in the device manager if you use the 32 bit Windows OS (Windows 2000, Windows XP).

   4. Right-click the device.

   5. Select Properties → Details → Hardware IDs.

   6. Find the VID/PID values.

   7. Run the WinObj utility.

   8. Open the GLOBAL?? folder.

   9. Find the string with the required USB device by the PID value.
       You will receive two types of USB address, any of which can be used to connect the board to Axxon One, for example:

      • \\?\USB#VID_13C0&PID_0070#5&521a615&0&10#{a5dcbf10-6530-11d2-901f-00c04fb951ed}
      • \\.\GLOBALROOT\Device\USBPDO-1
   10. In the Axxon One client, go to the Devices tab → Add device.
   11. In the Add device manually section:
       1. In the IP address parameter, enter one of the received USB addresses.
       2. In the Device type parameter, select IP device from the drop-down list.
       3. In the Vendor parameter, select StreamLabs from the drop-down list.
       4. In the Model parameter, select USBIO-16/8 from the drop-down list.
       5. Click the button.

...