Page History

The PTZ section is used for setting the telemetry control elements.

The settings panel for of the PTZ PTZ section is shown in the figure.

Image Modified

The setting parameters of the PTZ settings panel PTZ section are described in the table.

No	Parameter name	Field type	The way of specifying the parameter value	Parameter descriptionDescription	Representation	Default valueValue range	Range of values
1	The Delay between commands (ms) field	Type-Enter the value in the valuefield	Sets Sets the delay time between executing the commands for PTZ devicesthe execution of the PTZ device control commands. This parameter is not supported by isn't used for IP cameras.	ms	250	No limitations. It is not recommended to change We don't recommend changing the default value.
2	The Delay by priority (ms) field	Type-Enter the value in the valuefield	Sets the delay time before switch between switching from the PTZ control to a user with the interface, which has a priority that is lower or equal priority.to the priority that controls at the current moment	ms	30000	No limitations. It is not recommended to change We don't recommend changing the default value.
The Joystick group
3	The Sensitivity ( [1-, 10) ] field	Enter the value in the field	Sets sensitivity of the joystick sensitivity: the lower the less value, the more greater the sensitivity. If the value of the parameter is small then camera will react on even small deviations of the joysticklow, the camera reacts to small joystick deviations. If value of the parameter is great high, the camera will stay fixed stays motionless until the significant deviation of joystick deviation	Sensitivity in conditional units	5	1-101—10

Page tree