Versions Compared

Old Version 1

changes.mady.by.user Yulia Morozova

Saved on

compared with

New Version Current

changes.mady.by.user Bahdan Tsiulkou

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Go to the Hardware tab in the System settings dialog box window (1).
  2. Create the Edge storage object based on the Video capture device object in the objects tree of on the Hardware tab (2). In the right part of the Hardware tab the The setting panel of the selected object is displayed in the right part of the Hardware tab (3).

Connection parameters are configured You can set the connection parameters to the edge storage on the Video Capture Devicecapture device object settings panel – see panel—see Configuring video acquisition from IP devices. If they are you set them correctly, then after performing the steps above one can proceed to configure , you can set the list of cameras to access used for viewing the edge storage of the video archive (see the Setting the list of cameras to access the Edge storage section).

Note
titleImportantAttention!

Only one child You can create only one child Edge storage object can be created under on the basis of each Video Capture Devicecapture device object.

Creation of the Creating the Edge storage object is completedcomplete.