Page History

The You can configure the Fluid level detection module is configured on the the Fluid level detection object settings panel . This object that is created on the basis of the the Camera object on the Hardware tab of the System settings window.

The To configure the Fluid level detection module is configured as follows, do the following:

1. Go to the settings panel of the Fluid level detection object settings panel.
   

2. In From the Captioner drop-down list (1), select the Captioner object created on the basis of the same Camera object as the Fluid level detection object (1). This captioner will be is used to overlay captions of the fluid level onto value on the camera video image from a camera in the Video video surveillance monitor as captions.

   Info
   title Note
   For more info on how to create and configure the Captioner and Monitor objects, refer to the Axxon PSIM software. Administrator's Guide. For more details on operation of how to work with these objects, refer to the Axxon PSIM software. Operator's Guide . The (the most relevant versions of these documents are available in the AxxonSoft documentation repository).

3. Click the Settings button (2). The Detection settings dialog box window opens.
   
4. Select the frame in this settings window to set the area of interest. For that, click the Stop video button (1).
5. Click the Area of interest button (2). 

6. Using the left mouse button, select the four corners of the area on the captured video image (3). Only one area may be so designated. Upon selection of the On the captured video frame (3), sequentially set the anchor points of the area whose situation you want to analyze using the left mouse button. You can add only one area. After you add an area, the remaining part of the video image will be dimmedis darkened.
   
   

   Info
   title Note
   To remove a selected an area, click the button.

7. Click the OK button (4).
8. Click the Apply button (3)  on to save the settings on the Fluid level detection object settings panel to save the changes.

Configuring the Fluid level detection module is complete.