Page History

...

You can configure the Heat map detection

...

 module using the

...

settings

...

panel of the Heat map detection object that is created on the basis of the Camera object on the Hardware tab of the System settings window.

The

To configure the Heat map detection

...

 module, do the following:

1. Go to the settings panel of the Heat map detection settings panel object.
   
2. From the Area drop-down list, select the Area object to display the list of those regions
which
3. that belong to this area (1).
4. From the Region drop-down list, select the Region object to which
this detection should be referred
5. you want to refer this detector (2).

6. From the Time schedule drop-down list, select the corresponding time schedule

during

7. within which the

detection will work

8. detector operates (3).

   Note
   title Attention!
   If

no custom Time schedule objects is created

9. you don't create custom Time schedule objects in the system, then only two

time

10. time schedules are available—Always and Never. The Never time schedule is set by default,

so the detection tool will not work if the default settings are left unchanged

11. that is, the detector doesn't operate.

12. Click the Settings button (4). The Detection settings window will openopens.
    
13. Specify
the surveillance area and the approximate size of people in the video image
14. surveillance areas that you want to monitor using the detector:
    1. Click the Stop video button to capture the video image.
On
15. 1. In the captured video image, specify the areas that you want to
be analyzed
16. 1. monitor (1). To specify
the
17. 1. an area, set the
nodal
18. 1. anchor points of the interested area using the left mouse button. After
setting
19. 1. you set the last
nodal
20. 1. anchor point, click the right mouse button, and
closing
21. 1. the curve
will perform
22. 1. closing occurs automatically.
       Surveillance areas are numbered in the order of creation starting from
1. Adding
23. 1. one. When you add an area at the right
from
24. 1. of the video image, the corresponding button is displayed (2).
       Image Modified
    2. To remove
a selected
25. 1. an area, click
the
26. 1. the Image Modified button next to the
surveillance
27. 1. area number (
2
28. 1. 3).
29. Set the approximate person size as followson the image in the following way:
    1. Click the Size of person button  button (35).
    2. On the captured video image, set the approximate person size. To do this, use the left mouse button to select a the rectangular area (14).
    3. To remove the person size, click the Image Modifiedbutton next to
    the
    4. the Size of person button.
30. Setting Set the module parameters:
    1. Go to the Parameters tab of the Detection settings window (1) in the Detection settings window.
       Using the up-down buttons
    2. In the Sensitivity field (2), enter the sensitivity value
    of sensitivity parameter in the Sensitivity field (2)
    3. parameter using up-down buttons. The optimal value is selected experimentally by testing
    detection on triggering in the
    4. the detector for event generation in required conditions. The value range is from 0 to 100. The more sensitivity, the more possibility of false
    triggering
    5. event generation. The less sensitivity, the more possibility of losing the event.
31. Click the OK button.

Configuring the Heat map detection module  module is completedcomplete.