Go to documentation repository
Page History
To add fingerprints, do the following:
- On
...
- the settings panel of the BioSmart2 object
...
- Click , click the Control fingerprints button.
...
...
- Find a user by the ID or surname by clicking the Find button (Fig. 3.81, 1).
- Select the user (Fig. 3.81, 2) and click the Add fingerprint button (Fig. 3.81, 3).
- Select an available fingerprint reader and click the Select reader button (Fig. 3.82, 1-2).
...
- A dialog box showing fingerprint reading status opens.
- Put a finger on the reader and hold it until you hear a beep, then put another finger and repeat actions.Save fingerprints. When reading of the fingerprint is finished, a number of fingerprints read is displayed in the Fingerprint reading dialog box. A dialog box instructing to put the finger to the reader again opens.
Put the same finger on the reader and hold it until you hear a beep. Click Yes in the opened dialog box to save fingerprints or No to cancel input.
Info title Note Two copies of the same fingerprint, i.e. a comparison pair, are read per one cycle (steps 6-7). A Biosmart controller allows 5 comparison pairs per user.
- The number of fingerprints added for the selected user will be displayed in the Control fingerprints box
...
- .
...
...
Add fingerprints for all required users.
Info title Note
...
To delete fingerprints, select the user in the box and click the Delete fingerprints button
...
.
...
...
- Write the VMS data to controller (see Writing the VMS data to controller
...
- Send configuration to the controller (see Sending configuration to controller section). If the Send VMS data dynamically checkbox is set checked, then there is no need to perform this action.
| Note | ||
|---|---|---|
| ||
For correct user identification it is required to fill the Object code and the Card fields in the Visitor Management System interface module (see Adding user access cards using a reader). |
Fingerprints are now added to the system.
Overview
Content Tools