Page History

The You can configure the Stopped vehicle detection program module can be configured using on the System settings menu, under the Hardware tab, on the Stopped vehicle detection control panel, using the Camera settingspanel of the Stopped vehicle detection object that is created on the basis of the Camera object on the Hardware tab of the System settingswindow.

The To configure the Stopped vehicle detection module is set up as follows program module, do the following:

1. Go to the settings panel of the Stopped vehicle detection settings panel object.
   
2. Click the Settings (1) button. The Detection settings window will appearopens.

3. Configure the surveillance zones on the On the Select area tab (1). Several zones can be added , set the surveillance zones. You can set several surveillance zones (2). Detection tool triggering Detector generates a separate event in each surveillance zone produces a separate event.

   Info
   title Note.
   Both the For each surveillance zone, both vehicle stop and vehicle leaving the stopped vehicle that leaves the boundaries of the zone are detected in each surveillance zone.

   

   To add a surveillance set the surveillance zone, do the following:

   1. Click

      Start

      the Stop video button (3) to capture the frame of the video image.

   2. To add a zone, click

      any mouse button on

      the left and right mouse buttons on the frame of the video image.

   3. Set the required size, shape, and position of the surveillance zonethe surveillance zones:
      • To change the surveillance zone size, use the nodal anchor points of the zone;
      • To rotate the zone, drag it, while holding the mouse pointer close to the inner perimeter of the zone;
      • To move the zone around the frame of the video image, use a the dotted-line circle (4).

   4. Specify the approximate size of the vehicle in each surveillance zone by changing the size of the internal areas area in the bottom left corner of the main zone (5).  This field This area (5) is called the detection area.

      Info
      title Note.
      Each surveillance Each surveillance zone over its entire area is proportionally covered by detection areas of a given the specified size. It is necessary to You must set the approximate dimensions of the vehicle so that each surveillance each surveillance zone includes no more than 256 detection areas. To control the coverage of the zone by with detection areas, use the debug window window (see Appendix 1. Debug window). The stopped cars vehicles can be detected only in those parts of the surveillance the surveillance zone , which that are covered by with detection areas.

   5. Enter zone name the names of the zones (6).

   6. Select the direction of

      the vehicles moving towards the

      vehicle movement relative to the camera for

      each

      the surveillance zone (7).

4. Go to the Parameters tab (1) and set the minimal stop duration in seconds in the Stop duration, s field using the up and down buttons (2).
    Image Removed.
    Image Added
5. Set the Traffic jam detection checkbox to receive events about the traffic jams.
6. In the Stop duration (s) field, enter the minimal time of the vehicle stop in seconds.

7. In the Frames processed per second [0.016, 100] field, enter the number of frames that the detector processes per second. The higher the value, the more accurately the detector operates, but the higher the load on the CPU. The default value is 25 frames.

   Info
   title Note
   You can find all events received from the Stopped vehicle detection object in the Event viewer interface window. For more details, see Operating the Stopped vehicle detection module.

8. Click the OKbutton to save the changes and return to the settings panel of the Stopped vehicle detection object.
9. Click the Apply button on the settings panel of the Stopped vehicle detection objectClick OK.

Configuring the Stopped vehicle detection program module is completedcomplete.