Page History

Rules of the indicator state change enable changing change allow you to change the indicator of the BACnet object indicator on the map in case the map if a value of a property falls into in a given range.

The indicator and its property value are displayed in on the map (see Managing the property of the BACnet channel properties on the map).

Configuring of this rule is performed To configure these rules, set the following parameters on the Indicators tab on the settings panel of the Bacnet rule object. The settings description is presented below. It is possible to specify not more than 10 states of the indicator.Rule object:

1. Set the Enable checkbox Check the Enable box to activate the rule. 
2. In From the drop-down list in the Sign column, select the sign that will define determines the value range. The list of recognized signs differs for each supported value data type, see the table below.
3. Determine a value of a property in one of the following ways:
   1. In
   the 
   1. the Value column, enter
   the property
   1. the property value that
   will define
   1. limits the
   value
   1. range. The value must match
   the formatting rules for
   1. the data type of the
   BACNet property
   1.  BACNet property, for which the rule is configured
   for
   1. , see Configuring the BACnet Property.
    
   OR
   2. In the Minimum value and Maximum value fields, specify the interval the value must fall into.
4. In the Red, Green and Blue columns, define specify the color of the indicator colour according to the RGB model.
5. Click the Apply button to save the changes.

Image Added

You can specify up to 10 states of the indicator.Image Removed

The signs available for different value data types are listed in the table below: