Page History

General information

This command action allows you to check whether if a camera or a group of cameras is " armed " (see see Arming and Disarming disarming a Video Cameracamera).

Configuring an action

To configure this commandaction, do as follows:the following:

1. Go to the Programming tab.
2. In the Event rules or Cycle rules list, click Create... (see Configuring macros).
3. Select a start condition that triggers a macro (see Configuring start conditions).
4. Click the Image Added button below start conditions.
5. From the drop-down list, select Check if the camera is in armed mode.
6. In the Camera parameter, select a camera or
Select a camera or a
7. group of cameras that you
need
8. want to check
(1)
9. .
   
Image Removed
10. Image Added
    
Select
11. In the
response scenario
12. Execute if the camera is in armed mode parameter, select an action that must be executed if the checked camera is in armed mode.
13. In the Execute if the camera is
armed (2).Select the response scenario if the camera checked is not armed (3)
14. not in armed mode parameter, select an action that must be executed if the checked camera isn't in armed mode.
15. Click the Apply Image Added button.

Configuration of the Check if the camera is in armed mode action is complete.