Go to documentation repository
Page History
To
...
configure the
...
Noise detector, do the following:
Go to the
...
Detectors tab.
- Below the required camera, click Create… → Category: Service → Noise
...
- detector.
By default, the
...
detector is enabled and set to detect noise.
If necessary, you can change the
...
detector parameters. The list of parameters is given in the table:
| Parameter | Value | Description |
|---|---|---|
| Other | ||
| Enable | Yes | The |
| detector is enabled by default. To disable the |
| detector, select |
| the No |
| value | |
| No | |
| Name | Noise |
| detector | Enter the |
| detector name or leave the default name | |
| Type | Noise |
| detector | Name of the |
| detector type (non-editable field) | ||
| Basic settings | ||
| Alarm end delay | 10 | Enter the time in seconds during which the |
| generation of an event won't stop after the noise stops. If noise is detected again within the specified time, it |
| is considered as one event | ||
| Percentage of noise in audio stream | 2 | Specify the threshold value of noise in the audio stream as a percentage. If the value is exceeded, the |
| detector generates an event. You must select the value empirically in the range [0, 100] |
To save the parameters of the detection tooldetector, click the the Apply 
button. To To cancel the changes, click the Cancel 
button. .
Configuration of the Noise detector is complete.
Overview
Content Tools