Page History

...

...

Purpose

The map is used to monitor and control system devices (cameras, microphones, sensors, relays, etc.and so on) and to launch run macros.

Functions

The map provides has the following program functions:

1. Creation of a multi-level interactive map (graphic diagram) of the protected facility.
2. Interactive
3. Multilevel hierarchical object mapping (graphical chart forming) of a protected facility;
On-line
4. monitoring of the status of all system devices on the map
;
5. .
6. Virtual subdividing subdivision of a protected facility ;Possibility of automatic into areas and sections.
7. Automatic switching and search for recursive alarm links between layers on the map.
8. Control of the system's actuating devices on the map. recursive structural event analysis;Management of end devices;
9. Running macros.

Interface description

The shape type of the map depends on the layout of the protected facility structure; it and is assigned specified during the system setup procedure. An The figure below shows an example of a map for one floor of a protected facility is shown in the figure.:

System devices on the map are displayed as icons on the map. Each device has its status displayed, and access to its device functions is performed via the device functions function menu by right clicking on when you right-click the device icon on the map.

For example, the function menu of the Camera type object has a feature menu is shown in the figure.:

The map may can have multiple layers (levels). Then an interlayer link icon is used to toggle the layers.In this case you can use the icon of the map layer link to switch between layers.

The icon of the map layer Interlayer link:  

The map interlayer link indicates registered This icon also displays alarm events by any device registered by one of the devices on the appropriate corresponding map layer.