Page History

The number of PTZ devices connected to the Server server is specified in the license key bundled along with the Axxon PSIM™ distribution kit.  

Every Each PTZ device in Axxon PSIM has the corresponding corresponding PTZ device systemobject in Axxon PSIM™. The PTZ device object is a child object to the Telemetry Controller object.

The PTZ device configuration involves selection includes the stages of selecting the camera equipped with a by the PTZ device and setting PTZ MAC hardware addresses. When you use the absolute telemetry is in use, you will also have to configure points calibration (see Configuring calibration of points in camera FoV)., the calibration setup is required, see Configuring points calibration in the camera FOV.

Configure several PTZ devices Several PTZ devices are configured one after another.

To configure the PTZ devicesdevice, do the following:

1. Go to the Hardware tab in the setting panel of Axxon PSIM™ of the System settings dialog window (1).

2. Create a the PTZ device object under on the basis of the Telemetry controllerController system object, or select the relevant corresponding object in the object tree in on the Hardware tab of the System settings dialog box window (2).
   

3. Specify When you create the PTZ device object, you must specify the ID, the the object name of the PTZ device object and select the Telemetry controllerController object to which the PTZ device is connected (3).

4. Select the ID of the camera equipped with a by the PTZ device (4).

5. Select the name of the camera equipped with a by the PTZ device (5).

   Info
   title Note
   Specify You must specify either the video camera ID or its name.

6. In the Presets table, set the checkboxes checked next to the names of presets that are to be displayed on you want to display in the Telemetry control panel (see Telemetry the Configuring the telemetry control panel configuration section). Change the preset's name if necessary (6).

   Info
   title Note
   In order to To select all presets or cancel this operation, use the the Select/Deselect checkbox (7). The maximum number of presets depends on the device, see Appendix 6. Maximum number of presets for IP devices.

7. Set minimal and maximal In the Zooming group (8), set the minimum and maximum speed of the optical zoom in standard conventional units for the PTZ device in .

8. In the Zooming Mouse group (8).Set minimal and maximal 9), set the minimum and maximum rotation speed in standard conventional units for the PTZ device while mouse control when controlling from the Monitor in the Mouse surveillance monitor with the mouse.

9. In the Joystick group (9).

10. Set minimal and maximal rotation speed while joystick control in the Joystick group (10)

11. 10), set the minimum and maximum rotation speed in conventional units for the PTZ device when controlling with a joystick.

12. In the Point&Click group (11), set the minimum and maximum rotation speed of the PTZ device in the direction of the mouse pointer Set minimal and maximal rotation speed of PTZ device in direction of mouse click (Point&Click) in standard conventional units for the PTZ device in the Point&Click group (11)..

13. In the Device address field (12), you must specify the hardware Specify the MAC address of the PTZ device in the Device address field. The PTZ MAC hardware address corresponds to the address set on the PTZ device with the help of using jumpers or configured while programming when you program the PTZ device in with the bundled software (12).

14. If you want to disable the continuous PTZ mode (Continuous Mode) is to be disabledcontrol mode, set the the Force disabling continuous PTZ mode checkbox checked (13).

    Info
    title Note.
    If you clear the checkbox is set unchecked, then the continuous PTZ control mode is automatically enabled for the PTZ devices that support it.

15. To save the changes, click the Apply button (14).