Page History

Telemetry control panel is an interface object used for PTZ device control. The interface of the telemetry control panel interface is the same for all used PTZ devicesdevice types.

Create To create and configure the Telemetry telemetry control panel as follows, do the following:

1. Go to the Interfaces tab in the System settings dialog box window (1).
2. Create the Telemetry control panel object under object on the basis of the Display object or select the relevant corresponding object in the objects tree on the Interfaces tab of the System settings dialog box window (2).
   Image Modified
3. Specify When you create the Telemetry control panel object (3), specify the ID, the name of the Telemetry control panel object the object, and select the Display object under based on which the Telemetry control panel object is created (3).
4. Change Specify the X and Y coordinates of the telemetry control panel position on the screen. To do this, change the values in the relevant fields. The X and Y fields (4). The X and Y values correspond to the screen coordinates of the top upper left corner of the telemetry control panel , on the screen and are shown as percentage of the horizontal and vertical screen sizes correspondingly (4)expressed as percentages relative to the screen size horizontally and vertically.

5. Specify the dimensions of the Telemetry control panel interface object: the W (window width) and H (window height) fields (5). Dimensions  Dimensions are shown as percentage of the horizontal and vertical screen sizes correspondingly (5)expressed as percentages relative to the screen size horizontally and vertically.

   Info
   title Note
   The <Image Added button (6) is used for automatic input of the current object coordinates specified specified by the user when using the Telemetry telemetry control panel.

6. By default, you can drag the telemetry control panel can be dragged over the screen. To In this case, if you want to fix the telemetry control panel position, set clear the Allow window moving checkbox unchecked (7).

7. By default, the telemetry control panel is opaque. To display interface objects on located in the same screen with area as the telemetry control panel, set the Half-transparent window checkbox (8).

8. If it is necessary you want to change the PTZ control priority via using the Telemetry telemetry control panel, select the relevant required item in from the Priority list (9).

9. By default, the Operator operator is allowed to save the presets of the PTZ device (, that is, the presets of the camera position). To save presets, use . When you use the telemetry control panel, you can save presets using the digital buttons on of the Presets panel. To forbid the Operator to save operator from saving the presets of the PTZ device, set clear the Allow presets checkbox unchecked (10).

10. Set the Allow hotkeys checkbox checked if it is necessary (11) if you want to control the PTZ device via using the keyboard (11).

11. Move the names of the cameras equipped with PTZ devices to the Selected cameras list . These cameras will be controlled by the to control them by this Telemetry control panel object. You can To do this, you must move the selected cameras in turn, if you click one by one in the Selected cameras list by clicking the one-arrow button or move all cameras if you click equipped with the PTZ device by clicking the two-arrow button (12).Move

12. If necessary, move the camera names from the the Selected cameras list to the Available cameras with telemetry control list . These cameras will not be controlled by the to forbid the control over the specified cameras using this Telemetry control panel object. To do this, you must move the selected cameras in turn, click one by one in the Available cameras with telemetry control list by clicking the one-arrow button ; to or move all cameras , click to this list by clicking the two-arrow button (13).

13. To save the changes, click the Apply button (14).

Configuring the telemetry control panel is complete.