Page History

To configure alarm processing in the system, do the following:

1. Go to the Settings tab → the Options (1)tab → the Alarm processing (2).
   Image RemovedIn the item.
2. Set the required parameter settings specified in the table:
   

   Parameter	Value	Description
   Alarm processing
   Time period of operator reaction to alarm

field (3), enter

3. [hours], [minutes], [seconds]

   Specify the time during which

the

4. an alarm must be taken into processing

, otherwise

5. . Otherwise it is assigned the Skipped status. The

minimum value is 2 minutes

6. default value is 5 minutes. To change the time limit, specify the value in the range: hours [0, 96] minutes [2, 59] seconds [0, 59] Note title Attention! Minimum time limit is 0 hours, 2 minutes, 0 seconds. Info title Note To take an alarm into processing, you must switch to the Alarm management mode (see Switching to the Alarm management mode). After you take an alarm

is taken

7. into processing, the time for handling it is unlimited.

Set the maximum time for an alarm to stay on a special layout (4, see Working with Special

8. Time a camera is on alarm layout	[hours], [minutes], [seconds]	Specify the time period during which a camera is displayed on the alarm layout (see Configuring layouts). After the specified time

has elapsed

9. expires, the camera with alarm is removed from the alarm layout, and its place is taken by the next

alarm

10. camera, which

has not

11. hasn't yet been displayed on the layout.

12. By default, the time isn't set. To change the time limit, specify the value in the range: hours [0, 96] minutes [0, 59] seconds [0, 59]
    Obligatory bookmark with comment
    Confirmed alarm	Image Added	By default, when an alarm occurs, a comment isn't specified (the checkbox is cleared). If you want to specify the mandatory comment, set the checkbox
    	Image Added
    Suspicious situation	Image Added	By default, when an alarm occurs, a comment is specified (the checkbox is set). If you don't need the mandatory comment, clear the checkbox
    	Image Added
    False alarm	Image Added	By default, when an alarm occurs, a comment isn't specified (the checkbox is cleared). If you want to specify the mandatory comment, set the checkbox
    	Image Added

13. Click the Apply Image Added

14. Select the alarm assessment, after accepting which, the operator is required to enter a comment (5).

15. Click the Apply button.

Configuration of alarm processing is now complete.