Versions Compared

Old Version 13

changes.mady.by.user Alena Kniazeva

Saved on

compared with

New Version Current

changes.mady.by.user Darya Andryieuskaya

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

In Axxon One, you can configure macros to run the automatic system reactions based on the created face lists of faces (see Lists of faces Faces (AxxonNet),  Face lists Faces in Axxon Datacenter (Axxon Datacenter), Face lists Faces in AxxonData (AxxonData)), when:

  • the recognized face is present in the selected list;
  • the recognized face is absent in the selected list;
  • it is necessary to recognize the presence of the specific face from a list;
  • it is necessary to recognize the absence of the specific face from a list;
  • the recognized face is absent in all created lists.

To do this, do the following:

  1. Connect Axxon-domain to AxxonNet/AxxonData/Axxon Datacenter (see
    2. Configuring
  2. Configuration of a domain in AxxonNet, Configuring a domain
    3. ).Create one or more face lists
  3. in
    4. AxxonNet/
  4. AxxonData
    5. (see Lists of faces
  5. , 
    6. Face lists in AxxonData
  6. Configuration of a domain in Axxon Datacenter).
  7. Create a face detection tool detector (see Category: Face).

  8. Enable the Check in lists parameter in the settings of the face detection tool settings detector (see see Configuring the Face Detection TVdetector VL,  Configuring the Face Detection detector VA, Configuring the Face Detection VLdetector TV).

  9. Create one or more lists of faces in AxxonNet/AxxonData/Axxon Datacenter (see Faces (AxxonNet), Faces in AxxonData, Faces in Axxon Datacenter).
  10. Synchronize created lists of faces with a specific domain (see Synchronization of a list of faces with the domain (AxxonNet), Synchronizing a list of faces with the domain in AxxonData, Synchronization of a list of faces with the domain in Axxon Datacenter).
  11. Select the condition to start the automatic system reaction (
    12. see
  12. see Configuring start conditions
    13. for event-driven macros
  13. , Configuring macros when working with
    14. face
  14. lists of faces).
  15. Select one or more actions for the automatic system reaction (
    16. see Settings specific to actions
  16. see Examples of macros).
  17. If necessary, configure information boards to display the information from the automatic system reaction (
    18. see
  18. see Examples of macros used
    19. for
  19. when working with
    20. face
  20. lists of faces, Configuring an Event Board, Configuring a Dialog Board).