Versions Compared

Old Version 14

changes.mady.by.user Alena Kniazeva

Saved on

compared with

New Version Current

changes.mady.by.user Darya Andryieuskaya

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

In Axxon One, you can configure macros to run the automatic system reactions based on the created face lists of faces (see Faces (AxxonNet),   Faces in Axxon Datacenter (Axxon Datacenter), Faces in AxxonData (AxxonData)), when:

  • the recognized face is present in the selected list;
  • the recognized face is absent in the selected list;
  • it is necessary to recognize the presence of the specific face from a list;
  • it is necessary to recognize the absence of the specific face from a list;
  • the recognized face is absent in all created lists.

To do this, do the following:

  1. Connect Axxon-domain to AxxonNet/AxxonData/Axxon Datacenter (see
    2. Configuring
  2. Configuration of a domain in AxxonNet, Configuring a domain in AxxonData, 
    3. Configuring
  3. Configuration of a domain in Axxon Datacenter).
  4. Create a face detector (see Category: Face).

  5. Enable the Check in lists parameter in the settings of the face detector (see Configuring the Face detector VL, Configuring the Face detector VA, Configuring the Face detector TV).

  6. Create one or more
    7. face
  7. lists of faces in AxxonNet/AxxonData/Axxon Datacenter (see Faces (AxxonNet), Faces in AxxonData, Faces in Axxon Datacenter).
  8. Create a face detection tool (see Category: Face).
    9. Enable the Check in lists parameter in the face detection tool settings (see Configuring the Face Detection VL, Configuring the Face Detection VA, Configuring the Face Detection TV
  9. Synchronize created lists of faces with a specific domain (see Synchronization of a list of faces with the domain (AxxonNet), Synchronizing a list of faces with the domain in AxxonData, Synchronization of a list of faces with the domain in Axxon Datacenter).
  10. Select the condition to start the automatic system reaction (
    11. see
  11. see Configuring start conditions, Configuring macros when working with
    12. face
  12. lists of faces).
  13. Select one or more actions for the automatic system reaction (
    14. see Settings specific to actions
  14. see Examples of macros).
  15. If necessary, configure information boards to display the information from the automatic system reaction (
    16. see
  16. see Examples of macros used when working with
    17. face
  17. lists of faces, Configuring an Event Board, Configuring a Dialog Board).