Versions Compared

Old Version 2

changes.mady.by.user Evgeniya Kononova

Saved on

compared with

New Version Current

changes.mady.by.user Alena Kniazeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

It is possible to record a video signal received from a LP recognition video camera during a predetermined time interval. If this function is enabled, the recording starts automatically when the LPR channel recognizes an a LP number. 

Info
titleNote.

In case of heavy traffic, when subsequent LP numbers are registered in a time period smaller less than that specified, the video signal is recorded continuously.

To enable the function of automatic video recording functionality, do the following:

  1. Go to the settings panel of the LPR channel object settings panel, corresponding to the activated module (see Activating the software module used for identifying the plates section).

  2. Set the Auto Automatic recording checkbox (1) to enable the recording of the video upon recognizing an a LP number (1).

    Info
    titleNote.

    For correct auto recording when working with the IntLab program module specify the Pre-alarm record parameter in the settings panel of the Camera object (see Configuring video in the Pre-alarm record mode).

  3. In the field next to the checkbox (2), specify for how many seconds the video should must be recorded after LP number recognition.

    Info
    titleNote.

    Zero (0) If you specify 0 seconds in this field means that the recording starts at the moment of LP recognition and continues indefinitely, continuous rerording will start when the LP is recognized.


  4. Click the Apply button to save the settings (3).

...

  1. .