Page History

This section describes how to manage the configurations of all ZK Teco controllers connected to the ACFA PSIM Server at once. It is also possible to manage the configuration of each ZK Teco controller separately (see the Managing the configuration of a ZK controller section).

To manage the configurations of all ZK Teco controllers at onceTo configure the ZK Teco elevator control panel, do the following:

1. Go to the settings panel of the ZK EC10 controller object that is created on the basis of the AC ZK Teco parent object.
   
2. Click the Set current time to all devices button (1) to synchronize the time of all controllers with the Server time.
3. Click the Send access settings to all devices button (2) to start sending the access settings to all controllers.
4. Click the Cancel sending access settings to all devices button (3) to cancel sending the access settings to all controllers.
5. Click the Suspend sending access settings to all devices button (4) to suspend sending the access settings to all controllers.
6. Click the Progress sending access settings to all devices button (5) to resume sending the access settings to all controllers if it was previously suspended.
7. Set the Dynamic access settings checkbox to automatically send the data of the Access Manager module to all controllers (6).
8. Click the Apply button (7).

...

1.  Request date/time button to request the time of the ZK Teco elevator control panel. The result of the request will be displayed in the Event Viewer interface window.
2. Click the Sync time button to synchronize the time of the ZK Teco elevator control panel with the time of the Server.
3. Click the Send access settings button to send the access settings to the ZK Teco elevator control panel.
4. From the Entry to drop-down list, select the region located on the exit side of the door.
5. From the Exit from drop-down list, select the region located on the entry side of the door.
6. Click the Apply button.