To create configure the detection tool Noise detector, do the following:
Go to the
Detectors tab.
- Below the required camera, click Create… → Category: Service → Noise
Detection- detector.
By default, the detection tool detector is enabled and set to detect noise.
If necessary, you can change the detection tool detector parameters. The list of parameters is given in the table:
| Parameter | Value | Description |
|---|
| Other |
| Enable | Yes | The |
detection tool | detector is enabled by default. To disable the |
detection tool the value Detection detection tool | detector name or leave the default name |
| Type | Noise |
Detection detection tool | detector type (non-editable field) |
| Basic settings |
| Alarm end delay | 10 | Enter the time in seconds during which the generation of an event won't stop after the noise stops. If noise is detected again within the specified time, it |
will be | is considered as one event |
| Percentage of noise in audio stream | 2 | Specify the threshold value of noise in the audio stream as a percentage. If the value is exceeded, the |
detection tool will generate | detector generates an event. You must select the value empirically in the range [0, 100] |
To save the parameters of the detection tooldetector, click the the Apply 
Image Modified button. To To cancel the changes, click the Cancel 
Image Modified button. .
Configuration of the Noise detector is complete.
