Versions Compared

Old Version 2

changes.mady.by.user Bahdan Tsiulkou

Saved on

compared with

New Version Current

changes.mady.by.user Alena Kniazeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

In Axxon PSIM, you can convert video from fisheye cameras in the video surveillance monitor as well as in all camera windows opened when viewing video through other interfaces, for instance, through the Event Log (refer to event viewer (see Event control via Event Viewerevent viewer), when searching by captions (refer to see Search in the captions database), and so on.

You can select the conversion type when adding a camera to the Monitor monitor (see Selecting and configuring video cameras). To use this option, specify the lens type and fisheye camera position when configuring you configure it in Axxon PSIM in the following way:

  1. Go to the Additional Advanced settings tab on the settings panel of the Camera object corresponding to the fisheye camera.

  2. From the Lens type dropdown drop-down list, select:

    1. Standard for a standard fisheye lens.

    2. If you use a camera with a panamorphic lens, then select its type in this dropdown drop-down list.

    3. With some settings, there can be some artifacts at the top of the video for a standard fisheye lens. If there are such artifacts, then select the Autocalibration in this dropdown list.

      Note
      titleAttention!
      Video is calibrated every time you apply the settings

      drop-down list.

  3. From the Camera position dropdown drop-down list, select the value corresponding to the position of the configured camera: Floor, Wall, or Ceiling
  4. When you perform conversionAfter the conversion is performed, the edges of the frame edge areas can degrade or lose informationcan become blurry. By default, such degraded edges are cut offcropped, that is, they aren't visible on the video surveillance monitor. Default The default visible frame part is 75% for the the Ceiling position and 66% for the Wall position. To increase or decrease the displayed frame area, change the value of the Visible part parameter correspondingly. The value of this parameter is selected experimentally, depending on the camera.
  5. Click the Apply button.

Configuring Configuration of the fisheye camera is complete.