Versions Compared

Old Version 2

changes.mady.by.user Evgeniya Kononova

Saved on

compared with

New Version Current

changes.mady.by.user Bahdan Tsiulkou

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section
Column
width50%
Panel
borderColor#CCCCCC
bgColor#FFFFFF
titleBGColor#F0F0F0
borderStylesolid
titleOn the page:

Table of Contents


Column



Example 1.

The Regions regions created in the system are used to group Axxon PSIM system objects, representing PSIM objects corresponding to the security devices hardware by their its location on the protected territory.

To include a device into the Regionhardware in the region, select an appropriate Region in the Region field on the required Region from the Region list of the identification panel of the corresponding object on object on the Hardware tab.

Example 2.

Arming all cameras included into the in Region 1.1 when the Macro 2 1 is run. The parameters of the macro (Macro 1) essential for this operation are given in the table.

Event

Action

Parameters

Macro 2 is executed

The Control objects action of command of the Region 1.1 object is executed

Reaction type = ARM

Object type = CAM

Example 3.

In Axxon PSIM allows displaying the reports about the devices grouped in the Regions, you can display reports by the hardware grouped in regions.

The figure figures below shows show the configuration of the Event viewer object configuration , which allows you to display a report on the Alarm in area event on any device in the Region 1from any camera related to the Region 1.1 object.