Page History

...

1. Select a detector and click the button.
2. In the Surveillance windowthe surveillance window, click the mouse button.
3. Select  Skip area Ignore area in the list.

4. Set the anchor points of the area within which the detection won’t be performed.

   

   Info
   title Note
   Depending on the detector being configured, the area can be either rectangular or polygonal. When you set anchor points, they are connected by a two-color dashed line outlining the border of the area. For convenience of configuration, you can "freeze" the frame. Click the button. To cancel the action, click this button again. Once the area is closed, the buttons are available on its borders between the anchor points. When you click them, a new anchor point is added, allowing you to specify the most precise areas possible. To delete a selected area, click the button.

   Action	Result
   Left-click or right-click in the Surveillance surveillance window	Creates a new anchor point of the area
   Right-click a created anchor point	Deletes an anchor point of the area
   Hover the mouse cursor over an anchor point and, holding down the left mouse button, move the mouse	Moves an anchor point of the area

5. Specify all required areas.

6. Click the Apply button. To cancel the changes, click the Cancel button.

Configuration of a skip the ignore area is complete. Skip  Ignore areas are relevant for all sub-detectors created on the basis of the parent detector.