Page History

...

You can configure the Heat map detection

...

 module using the

...

settings

...

panel of the Heat map detection object that is created on the basis of the Camera object on the Hardware tab of the System settings window.

The

To configure the Heat map detection

...

 module, do the following:

1. Go to the settings panel of the Heat map detection control panel object.
   
2. From the Area drop-down list, select the Area object to display the list of those regions
which
3. that belong to this area (1).
4. From the Region drop-down list, select the Region object to which
this detection is to be referred to
5. you want to refer this detector (2).

6. From the Time schedule drop-down list, select the corresponding time schedule

during

7. within which the

detection will work

8. detector operates (3).

   Note
   title

Important

9. Attention!

   If

no custom Time zone objects is created

10. you don't create custom Time schedule objects in the system,

  two time zones

11. then only two time schedules are available

–

12. —Always and Never. The Never time

zone

13. schedule is set by default, that is,

so the detection tool will not work if default settings are left unchanged

14. the detector doesn't operate.

15. Click the Settings button (4). The Detection settings window will appearopens.
    
16. Specify
the area of interest and the approximate size of people in the video image
17. surveillance areas that you want to monitor using the detector:
    1. Click the Stop video button to capture the video image.
On
18. 1. In the captured video image, specify the areas that you want to
be analyzed
19. 1. monitor (1). To specify
the
20. 1. an area, set the
nodal
21. 1. anchor points of the interested area using the left mouse button. After
setting
22. 1. you set the last
nodal
23. 1. anchor point, click the right mouse button, and
closing
24. 1. the curve
will perform
25. 1. closing occurs automatically.
       
Areas of interest
26. 1. Surveillance areas are numbered in the order of creation starting from
1. Adding
27. 1. one. When you add an area at the right
from
28. 1. of the video image, the corresponding button is displayed (2).
       Image Modified
    2. To remove
a selected
29. 1. an area, click
the
30. 1. the Image Modified button next to the
Area of interest button
31. 1. area number (3).
32. Set the approximate person size as followson the image in the following way:
    1. Click the Size of manperson button (5).
    2. On the captured video image, set the approximate person size. To do this, use the left mouse button to select a the rectangular area (14).
    3. To remove the person size, click the Image Modifiedbutton next to
    the
    4. the Size of
    man button
    5. person button.
33. Setting Set the module parameters:
    1. Go to the Parameters tab of the Detection settings window (1) in the Detection settings window.
       Using the
    2. In the Sensitivity field (2), enter the sensitivity value parameter using up-down buttons
    enter the value of sensitivity parameter in the Sensitivity field (2)
    3. . The optimal value is selected experimentally by testing
    detection on triggering in the
    4. the detector for event generation in required conditions. The value range is from 0 to 100. The more sensitivity, the more possibility of false
    triggering
    5. event generation. The less sensitivity, the more possibility of losing the event.
34. Click the OK button.

Configuring the Heat map detection module  module is completedcomplete.