Versions Compared

Old Version 3

changes.mady.by.user Alena Kniazeva

Saved on

compared with

New Version Current

changes.mady.by.user Darya Andryieuskaya

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

General information

This action allows you Use this action to transmit audio from the Clientclient's microphone to the selected speaker.

Note
titleAttention!

If a Client the client is behind the NAT, you have to must specify the external IP address of the switch for this Client with and a port range of at least 1000 ports on the client (see see Network settings utility).

Configuring an action

To configure this action, do as followsthe following:

  1. Go to the Programming tab.
  2. In the Event rules or Cycle rules list, click Create... (see Configuring
    3. Configure the conditions to start a macro (see Configuring filters for event-driven
  3. macros).
  4. Select a
    5. speaker (1).
    Image Removed
  5. Select a microphone (2).
  6. Specify sensitivity from 0 to 100 (3).

To stop sound, use the Stop voice notification from client command on the Client.

  1. start condition that triggers a macro (see Configuring start conditions).
  2. Click the Image Added button below start conditions.
  3. From the drop-down list, select Voice notification from client.
  4. In the Speaker parameter, select the corresponding speaker.
    Image Added
  5. In the Microphone parameter, select a microphone.
  6. In the Sensitivity parameter, specify the microphone sensitivity for audio transmission from 0 to 100.
  7. Click the Apply Image Added button.

Configuration of the Voice notification from client action is complete.To configure this command, select a speaker (4) and a microphone (5).