Versions Compared

Old Version 3

changes.mady.by.user Bahdan Tsiulkou

Saved on

compared with

New Version Current

changes.mady.by.user Bahdan Tsiulkou

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Go to the Settings tab → Options tab → NTP synchronization item.
  2. Configure parameters specified in the table:
    ParameterValueDescription
    NTP synchronization
    Enable

    		By default, the NTP synchronization is disabled (the checkbox is cleared). To enable the NTP synchronization, set the checkbox

    NTP server address
    		Specify the address of the required NTP server
    Synchronization intervalMinutes
    Note
    titleAttention!

    If you clear the checkbox in the Enable field, then this field is unavailable.

    The default value is 1140 1440. If necessary, change the time interval. The value must be in the range [15, 10080]

    Synchronize on IP devices

    By default, the time synchronization for IP devices connected to the server is disabled (the checkbox is cleared). To enable synchronization, set the checkbox

    Info
    titleNote

    NTP time synchronization on IP devices works only for devices connected via the ONVIF protocol.

  3. Click the Apply button. To cancel an action, click the Cancel button.

...