Page History

...

1. Go to the settings panel of the LPR channel object corresponding to the activated software module (see Activating the software module used for identifying license plates).
   

   Info
   title Note
   The availability of the parameters depends on the activated software modules (for details, see The settings panel of the LPR channel object).

2. Set Specify the Area search threshold parameter.

3. Set Specify the Max. width and Max. height parameters:

   1. Click the  button button next to the parameters. Interactive An interactive interface for setting up zone parameters, representing parameters of an area opens. It represents an image from the corresponding camera, is displayed.
      

   2. At the appropriate required moment, click the Stop video button, then select the required zone area using the left mouse button and click the OK button.

      

      Info
      title Note
      You can select the required zone area in the same way in the Real Time Video the Live video mode.

      Results of setting zone area parameters are automatically entered in the the Max. width and Max. height fields.

      Info
      title Note
      We don't recommend setting maximum sizes greater than required, as this slows down the processing but doesn't improve the recognition quality.

4. Set Specify the Min. width and Min. height parameters similarly to the Max. width and Max. height parameters using the button.

5. If necessary, set the Cut image with vehicle checkbox.

   Info
   title Note
   The cut Cut image with vehicle option is used only when you work with megapixel video surveillance cameras.

6. If necessary, set the Allow recognition by request checkbox.
   

   Info
   title Note
   Image recognition by request works only for the RR (seeSearching for a license plate by image)and VT (see Search for a license plate by image for the VT recognition module) modules. For this, use the POST http://IP address:port/lprserver/FindNumbersByImage query. The response can contain the following mistakeserrors: In this case, the Allow recognition by request checkbox isn't set. In this case, an image of the incorrect base64 format is used: you must convert the video frame to the JPEG format but and not save it in the JPG format. In this case, you used the Uragan module during the operation; image recognition by request isn't supported.

7. Click the Apply button.

...