Page History

The You can configure the Barcode detection module can be configured using on the System settings menu, under the Hardware tab, on the Barcode detection control panel, using the Camera settingspanel of the Barcode detection object that is created on the basis of the Camera object on the Hardware tab of the System settings window.

Image ModifiedThe

To configure the Barcode detection

...

 module, do the following:

1. Go to the settings panel of the Barcode detection
control panel
2.  object.
   Image Modified
3. From the Captioner drop drop-down list (1), select the captioner with the help of which a result will be is displayed in on the monitor (1).

4. In the Skip repeated recognitions (s) field, s field enter the time in seconds in which the repeated code is recognized (2).

   Info
   title Note.
   If there are some different barcodes or QR-codes one after another, then the recognition is performed instantly. If there are some repeated barcodes then , the new result will be is displayed after the time period specified in the settings.

5. Click the Settings button (3). The Detection settings window will appearopens.
6. Specify the detection surveillance area:
   1. Click the Stop video button to capture the video image (1).
      
   2. Click the Area of interest button (2).
      
   3. On the captured video image specify areas to be analyzed. It is possible to , set the detection area that you want to monitor. You can add only one area. While attempting When you try to add the second area, the first one will be is deleted. After you add an area specifying , the remaining part of the video image will be is darkened.

      Info
      title Note.
      To remove the area, click the Image Removed Image Added button next to the Area of interest button.

      Note
      title Attention!
      Barcode can Barcodes can be detected not only when the entire barcode or QR code is within the specified area, but also only a fragment of itincluding its fragment.

   4. Click  the OK button (3) to save the changes and return to the control settings panel of the Barcode detection object.

      Info
      title Note.
      To return to the control settings panel of the Barcode detection object without saving the changes, click the Cancel button.

7. On the Barcode detection control panel, click Click the Apply button (4) on the settings panel of the Barcode detection object.

Configuring the Barcode detection module is complete.

...