Page History

To configure alarm processing in the system, do the following:

1. Go to the Settings tab → the Options  tab → the Alarm processing item.
2. Enter Set the required parameter settings specified in the table:
   
   Mandatory

   Parameter	Value	Description
   Alarm processing
   Time period of operator reaction to alarm	[hours], [minutes], [seconds]	Enter Specify the time during which an alarm must be taken into processing. Otherwise it is assigned the Skipped status. The default value is 5 minutes. To change the time limit, specify a the value in the range: hours [0, 96] minutes [2, 59] seconds [0, 59] Note title Attention! Minimum time limit is 0 hours, 2 minutes, 0 seconds. Info title Note To take an alarm into processing, you must switch to the Alarm management mode (see Switching to the Alarm management mode). After you take an alarm into processing, the time for handling it is unlimited.
   Time a camera is on alarm layout	[hours], [minutes], [seconds]	Enter Specify the time period during which an alarm a camera is displayed on the alarm layout (see Working with Special Configuring layouts). After the specified time has elapsedexpires, the camera with alarm is removed from the alarm layout, and its place is taken by the next alarmcamera, which has not hasn't yet been displayed on the layout. By default, the time isn't set. To change the time limit, specify a the value in the range: hours [0, 96] minutes [20, 59] seconds [0, 59]
   Obligatory bookmark with comment
   Confirmed alarm		By default, when an alarm is triggeredoccurs, a comment isn't provided specified (the checkbox is clearcleared). If a you want to specify the mandatory comment is required, set the checkbox
   Suspicious situation		By default, when an alarm is triggeredoccurs, a comment is provided specified (the checkbox is set). If a you don't need the mandatory comment isn't required, clear the checkbox
   False alarm		By default, when an alarm is triggeredoccurs, a comment isn't provided specified (the checkbox is clearcleared). If a you want to specify the mandatory comment is required, set the checkbox checkbox

3. Click the Apply button.

Configuration of alarm processing is complete.

...