Versions Compared

Old Version 6

changes.mady.by.user Gleb Matskevich

Saved on

compared with

New Version Current

changes.mady.by.user Yulia Morozova

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

A telemetry control panel is used to control PTZ devices. The Control panel system object is used for the PTZ control panel hardware device registration in INTELLECT™ Intellect.

Info
titleNote.

Some of the PTZ control panels may be registered as Control device – see Configuring the Control device object.

...

  1. Go to the Hardware tab in the System settings dialog box (1).

  2. Create the Control panel system object under the Telemetry Controller object or select the relevant object in the Hardware tab of the System settings dialog box (2).

    Note
    titleAttention!

    If control panel is connected using the USB interface, then all settings related to COM-port are ignored by system. In this case go to step 8.


  3. Specify the ID, the name of the Control panel object and select the Telemetry controller object to which the PTZ device is connected.

  4. Select the COM port number in the Port list in order to connect the Control panel device (3).

    Info
    titleNote

    The Control panel is connected to the COM port different from that to wich which the PTZ device is connected. Therefore another COM port number must be specified on the settings panel of the parent (for the the Control panel object) Telemetry Controller object.


  5. Specify the speed of data exchange between the computer and the telemetry control panel device if necessary (4).

  6. Specify parity check parameters for the data exchange if necessary (5).

  7. If the telemetry control panel device is passive (i.e. with no independent power supply), the power supply is to be activated via the DTR or RTS outputs of the COM port by setting the DTR or RTS check boxes (6,7).

    Info
    titleNote

    The COM port speed and parity settings of the parent Telemetry controller object do not relate to the similar settings of the Control panel object as they refer to another COM port.


    Info
    titleNote

    The Speed and Parity settings must be the same as the COM port settings in the Windows OS.


  8. Change the PTZ device control priority for the telemetry control panel device, select the relevant item in the Priority list (8).

  9. To save the changes click the Apply button (9).